Ich habe ein NM-16ESW-PWR-1GIG Modul im Cisco 2821 Router.
Ich bekomme kein PoE
Muß ich noch was dafür aktivieren?
Kann man den PoE Status abfragen? Habe da kein show Befehl für gefunden.
Sh Interface:
FastEthernet1/0 is up, line protocol is up
Hardware is Fast Ethernet, address is 0021.55b9.d3c6 (bia 0021.55b9.d3c6)
MTU 1500 bytes, BW 100000 Kbit/sec, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:58, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 2000 bits/sec, 1 packets/sec
5 minute output rate 3000 bits/sec, 5 packets/sec
34831 packets input, 9295226 bytes, 0 no buffer
Received 685 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
57419 packets output, 23719990 bytes, 0 underruns
0 output errors, 0 collisions, 2 interface resets
124 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
